Thursday, December 02, 2010
You Can't Catch Me, I'm the Gingerbread Man
I never need an excuse to get crafty. I never need an excuse to eat cookies. When I get the opportunity to do both simultaneously, a happy girl am I. Archway Cookies is hosting a little photo challenge with my hero Babette of BakeSpace fame, so I had to throw my name in the hat. I scored a bulging box of holiday cookies from Archway with the instructions to create something that would capture the holidays and snap a photo. No baking required. Most of the cookies were too soft to use for any real crafting, since I wanted to make something that would last. No sense creating something I'll just have to toss! Luckily they were all good enough to eat, especially the Candy Cane flavor (which was gone in a day. Actually, hours.). The Gingerbread Men were the only cookies I thought might hold up, so this garland was born.
As a bonus, BakeSpace and Archway are offering an ultimate gift box of cookies for one lucky voter. The poll is up, and all you need to do is leave a comment to vote and be entered in the cookie drawing. I'm #12 and, as always, I appreciate your support! Click here to vote!
Want to make you own garland? Here's how:
Gingerbread Man Garland
What you'll need:
One bag of Archway Gingerbread Men
Spray Shellac or Lacquer
Mod Podge, Sparkle
E6000 craft adhesive aka the best stuff ever
1/2 inch Eye Pins
Red and Clear Crystal Beads
What you'll do:
Step 1: Sort through your bag of cookies and set all of the whole gingerbread men aside. Stuff the broken ones in your mouth.
Step 2: Using a pastry brush, brush all of the crumbs from all sides and edges of the cookies.
Step 3: Lay the brushed cookies out on a non stick, disposable surface outside or in a well ventilated area, like your garage. I used a slick poster board, but parchment or wax paper would work. Make sure you read the instructions and drying times on the can before you start! Spray well with a coat of shellac or laquer (or if you're like me, have your husband do it. Those fume aren't good for baby!) Once dry, flip and spray the backs. Repeat to give cookies three coats of shellac.
Step 4: Move your little project inside where it's warm. Using a foam brush, brush each cookie with a coat of Sparkle Mod Podge. Yes, it looks white, but don't fret. It will dry clear and shimmery. Allow to dry completely.
Step 5: Carefully slide an eye pin straight down into the top of each cookie. Right into the little man's noggin. Be gentle! Even though you've sealed them, they can still break! Remove the eye pin, dip into E6000, and slide back into the hole. Wipe any excess glue and allow to dry overnight.
Step 6: Measure out your desired length of baker's twine. Make a knot a few inches from one end and string on beads and a cookie in your desired pattern. Make another knot next to the last bead. I used three fingers to measure the spaces between cookies and tied another knot before continuing to string. Repeat until you run out of cookies or twine.
Don't know what to do with any leftover cookies? Make earrings for your Tacky Christmas Sweater Party, use them as pendants for cute kids, or tie them to gifts to spice up your wrapping. I think they would be adorable on boxes wrapped in brown kraft paper and tied with baker's twine!
*Note: I received this box of holiday cookies from Archway for free, under no commitment to review them. All of the comments and opinions shared here are my own.